How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask -Brad- Your Own Question
-Brad-
-Brad-, Dodge Dealership Tech
Category: Dodge
Satisfied Customers: 6961
Experience:  16 Yrs Chrysler/Dodge Technician. ASE Master Certified(L-1)
10114124
Type Your Dodge Question Here...
-Brad- is online now
A new question is answered every 9 seconds

How do you program a keyless remote for a 2005 Stratus

This answer was rated:

How do you program a keyless remote for a 2005 Stratus without using an existing working remote.

Welcome to JustAnswer!!! My name is***** will be helping you with your question today...

To program a remote you will need the DRBIII that I use here at the dealership, we charge 55.00 to program keys and remotes..

If you need anymore assistance feel free to reply and don't forget the RATING before leaving the site!!

Have a great day,

Brad

If you had another working remote you could do this:

STANDARD PROCEDURE - RKE TRANSMITTER PROGRAMMING

The Remote Keyless Entry (RKE) Transmitter(s) can be programmed with the use of the DRB III® scan tool, or by the customer.

New Remote Keyless Entry (RKE) transmitters can be programed using the DRBIII® scan tool and the proper Diagnostic Procedures manual, if no functioning transmitter is available. The DRBIII® scan tool can provide confirmation that the PCI data bus is functional, and that all of the electronic modules are sending and receiving the proper messages on the PCI data bus.

The following procedure can be used as long as one functioning transmitter is available:

  1. Turn ignition to the RUN position (allow ignition chimes to stop).
  2. Using any original (working) transmitter, press the UNLOCK button for 4 to 10 seconds.
  3. Within the specified 4 to 10 seconds, continue pressing the UNLOCK button and press the PANIC button for 1 second, and release both buttons. A chime will sound to indicate that the transmitter programming mode has been entered (allow 3 seconds for chime to sound).
  4. Press LOCK and UNLOCK buttons simultaneously for 1 second and release.
  5. Press and release any button on the same transmitter and a chime will sound after successfully programming the transmitter.
  6. Repeat steps 5 and 6 to program additional transmitters.
  7. Turn ignition to the OFF position. Transmitter programming mode will discontinue after 60 seconds. All transmitter programming must be completed within time specified

Since you don't you will need the DRBIII..

If you need anymore assistance feel free to reply and don't forget the RATING before leaving the site!!

Have a great day,

Brad

-Brad- and 4 other Dodge Specialists are ready to help you