How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask AZTechBrian Your Own Question
AZTechBrian
AZTechBrian, ASE Certified Technician
Category: Dodge
Satisfied Customers: 706
Experience:  Owner
77606712
Type Your Dodge Question Here...
AZTechBrian is online now
A new question is answered every 9 seconds

Replaced the cam sensor and the crank shaft sensor and still

Customer Question

Replaced the cam sensor and the crank shaft sensor and still getting the p0522 code and truck will turn over but not start.
Submitted: 11 months ago.
Category: Dodge
Expert:  AZTechBrian replied 11 months ago.

Hello. The P0522 code is indicating low oil pressure and is most often caused by a bad oil pressure sending unit. Replacement of that part will usually resolve that particular code. The no start condition however probably is not related to the oil pressure sending unit. I would start with the fuel pump. When you turn your key to the on position, can you hear your fuel pump run for a few seconds? It's located in the tank and it should run for a few seconds when you turn the key to the on position without cranking the engine. If it does not run then you likely have a bad pump, or a damaged wire going to the pump. You can try spraying some starting fluid into the intake to see if the engine will run for a few seconds.