How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 21806
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
9825021
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

I have a 2004 Dodge Diesel. I replaced the Throttle Position

Customer Question

I have a 2004 Dodge Diesel. I replaced the Throttle Position Sensor because that was what the check engine code indicated. $350 later it still will run and then act like a switch flips and goes into limp mode.
Submitted: 1 year ago.
Category: Dodge
Expert:  sprinkles08 replied 1 year ago.
Hello and welcome to JustAnswer!
If you're setting an accelerator pedal positions sensor code possible causes would be the sensor itself, wiring and connections, or the engine controller. ECM issues on these are very rare, if you replaced the sensor with a known good part and it's still setting a code then you almost certainly have a wiring issue.
What P codes are currently setting?
Customer: replied 1 year ago.
It was a p2121 and a p2127 and we even replaced the tps that is under the battery box on the drivers side
Expert:  sprinkles08 replied 1 year ago.
That's the cruise control servo.
Do you have the part numbers for any parts replaced?

Related Dodge Questions