How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 22301
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
9825021
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

I have a 2002 dodge ram 1500. The truck has a 5.7 hemi, the

Customer Question

I have a 2002 dodge ram 1500. The truck has a 5.7 hemi, the previous owner swapped out the 4.7. I have a abs, airbag, brake, and no a/c
Submitted: 1 year ago.
Category: Dodge
Customer: replied 1 year ago.
The 5.7 hemi came out of a 2004 dodge ram 1500
Customer: replied 1 year ago.
I have replaced the rear abs sensor on rear diff no change
Customer: replied 1 year ago.
My speedometer isn't working as well
Customer: replied 1 year ago.
Posted by JustAnswer at customer's request) Hello. I would like to request the following Expert Service(s) from you: Live Phone Call. Let me know if you need more information, or send me the service offer(s) so we can proceed.
Customer: replied 1 year ago.
Need help plz
Customer: replied 1 year ago.
Have checked all fuses with meter, and checked all wires in c2 plug under the fuse box
Expert:  sprinkles08 replied 1 year ago.
Hello and welcome to JustAnswer!
There are quite a few things that could be going on. I'm assuming that everything operated correctly after the engine was replaced.
If all of these problems started at once I would first suspect a wiring issue or internal failure in the integrated power module. The ABS module, a/c control head and airbag module all rely on power from the ignition switch. It's possible that your switch has failed or there may be a connection issue at the switch due to heat damage, but I've seen wiring damage under the IPM cause this as well as internal issues in the IPM.
Does fuse 35 have power with the key on?
Customer: replied 1 year ago.
I think I found the problem, he did not switch the abs control modules when he did the swap. Thanx tho
Expert:  sprinkles08 replied 1 year ago.
If there was a VIN mismatch between the PCM and ABS module then the ABS light would be on with a VIN mismatch code, the same would go for the airbag module. This wouldn't explain an issue with the a/c though.
Customer: replied 1 year ago.
Will u be available tomorrow to troubleshoot
Expert:  sprinkles08 replied 1 year ago.
I will be online tomorrow.

Related Dodge Questions