How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dodge expert Your Own Question
Dodge expert
Dodge expert, ASE Cert Technician
Category: Dodge
Satisfied Customers: 10370
Experience:  30 years experience, ase certified,shop owner
22989858
Type Your Dodge Question Here...
Dodge expert is online now
A new question is answered every 9 seconds

2003 dodge neon: heater..blow..car is not overheating..core

This answer was rated:

The heater in my 2003 dodge neon is not working right. Sometimes it doesnt blow any air and its making a funny noise when you turn it on. The car is not overheating so I dont think its the core.
Welcome to just answer.com. I'm here to help you and your 100% satisfaction is my goal.If you have no airflow out all pin most likely we have some sort of problem with blower unit itself will need to remove it and make sure the blower wheel is attached properly to the blower motor
Customer: replied 5 years ago.
Sometimes it does blow air. Right now it is blowing but there is an odd sound. The air flow stops and starts irratically.
Yes is the airflow was stopping and starting with the excess noise then remove the blower motor and checked the fan blower housing itself
Customer: replied 5 years ago.
I need instruction on how to do that. Where is it located? What do I need to know before I attempt this. Should I try to do it myself or find an expert?


Blower Motor Replacement - w/ Air Conditioning

NOTE: The blower motor is located on the bottom right side of the unit housing. The blower motor can be removed from the vehicle without having to remove the unit housing assembly.

REMOVAL

  1. Remove left side scuff plate.
  2. Pull back carpet.
  3. Disconnect blower motor wiring connector.

Fig.31 Blower Motor Retaining Screws

  1. Remove blower motor retaining screws, and lower blower motor assembly from unit housing.

INSTALLATION

  1. Position the blower motor into the unit housing.
  2. Install the blower motor retaining screws.
  3. Connect the wire harness to the blower motor.
  4. Reposition the right side carpet.
  5. Install the left side scuff plate.
Customer: replied 5 years ago.
So am I correct in assumeing this is on the passengers side inside the car?
yes absolutley
Dodge expert and 5 other Dodge Specialists are ready to help you