How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff, ASE Certified Technician
Category: Dodge
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
Type Your Dodge Question Here...
brownjeff is online now
A new question is answered every 9 seconds

How to replace valve cover gasket in 1998 dodge grand caravan 3.

This answer was rated:

How to replace valve cover gasket in 1998 dodge grand caravan 3.0 L engine
Hello and Welcome to JustAnswer,

My name is XXXXX XXXXX I am here to try and assist your with your question. Are you replacing the front or rear?
Customer: replied 5 years ago.

The front


  1. Disconnect negative cable from battery.
  2. Remove air inlet resonator when removing left head cover.
  3. When Removing left cylinder head cover, remove dipstick tube.
  4. When removing right cylinder head cover remove wiper unit.
  5. When removing right cylinder head cover, remove accessory drive belt.
  6. When removing right cylinder head cover, disconnect generator wiring and remove generator.
  7. Relocate spark plug wires.
  8. Remove vacuum connections.

  1. Remove rocker cover screws and remove cover.


  1. Clean cylinder head and cover mating surfaces. Install new gasket.
  2. See image and apply sealant such as Mopar (R) Silicone Rubber Adhesive Sealant to cover ends.
  3. Install cover and tighten cover bolt washer and gasket assembly to 10 Nm (88 inch lbs.) .
  4. Reverse removal procedures for installation.
brownjeff and 3 other Dodge Specialists are ready to help you

Related Dodge Questions