What size motor do you have?
Did you loosen all 3 bolts?
yes, one on top and 2 on bottom that are the ones that seem to be in sliding type holes
and it still does not move
I would think that is all that is needed, but i can't get it to move to put new belt on (old one broke)
You can use a 1/2 inch drive ratchet to slide it.
I will try again...i tried to get a 1/2 inch drive in there but couldn't due to the pully
Sometimes they just get stuck and are hard to move.
thanks. actrualy the diagram helped ...had loosened both bolts on front, but did not see the one on the back
I'm all set.
That's great news, let me know if you need anymore help.
PS: don't forget to hit the accept button, I will not get credit for my work until you do.