How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask moparfl Your Own Question
moparfl
moparfl, ASE Certified Technician
Category: Dodge
Satisfied Customers: 6330
Experience:  ASE Master Tech Gold level Chrysler Status 30 years dealership exp
13195827
Type Your Dodge Question Here...
moparfl is online now
A new question is answered every 9 seconds

2008 dodge charger, how do you change turn signal bulb without

Resolved Question:

2008 dodge charger, how do you change turn signal bulb without damaging assembly.
Submitted: 6 years ago.
Category: Dodge
Expert:  moparfl replied 6 years ago.

REMOVAL


SEDAN


1.Disconnect and isolate the battery negative cable.
2.From inside the trunk, peel back the trunk trim and disconnect the electrical connector.


3.Remove the three plastic wing nuts (3).
4.Pull the tail lamp unit (1) straight out of the rear of the quarter trim panel.


WAGON


1.Disconnect and isolate the battery negative cable.
2.Remove the two push fasteners (1) in the liftgate opening.


3.From inside the cargo area, using a trim stick (special tool #C-4755) or equivalent, gently pry the access panel off the rear of the quarter trim panel.
4.Remove the one plastic wing nut.


5.Pulling rearward, release the mounting tabs of the tail lamp unit (1).


6.Disconnect the electrical connector (3) from tail lamp unit (1).


1.Twist counterclockwise to remove the Stop (1), Turn Signal (2), or Back-Up lamps.
moparfl and 3 other Dodge Specialists are ready to help you

Related Dodge Questions