How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask rich Your Own Question
rich
rich, ASE Certified Technician
Category: Dodge
Satisfied Customers: 368
Experience:  19 years at chrysler-dodge-jeep dealer
18317595
Type Your Dodge Question Here...
rich is online now
A new question is answered every 9 seconds

How do you get to the blower motor on 1998 dodge durango?

Customer Question

how do you get to the blower motor on 1998 dodge durango?
Submitted: 7 years ago.
Category: Dodge
Expert:  rich replied 7 years ago.

here are the remove and install directions--if a picture link does not come up let me know--you need to remove the ac unit first

 

 

FRONT

REMOVAL

  1. Remove and disassemble the heater-A/C housing. See Heater-A/C Housing in the Removal and Installation section of this group for the procedures.
  2. Remove the three screws that secure the blower motor, air spoiler, and blower wheel assembly to the heater-A/C housing Blower Motor Remove/Install
  3. Pull the blower motor and wheel assembly out of the passenger compartment side of the heater-A/C housing while feeding the blower motor wire harness, grommet and connector through the hole on the dash panel side of the housing.
  4. Remove the blower wheel retainer clip and remove the wheel from the blower motor shaft Blower Motor Wheel Remove/Install

INSTALLATION

  1. Press the blower wheel hub onto the blower motor shaft. Be sure the flat on the blower motor shaft is indexed to the flat on the inside of the blower wheel hub.
  2. Install the retainer clip over the blower wheel hub. The ears of the retainer clip must be indexed over the flats on the blower motor shaft and blower wheel hub.
  3. Place the blower motor, air spoiler, and wheel assembly inside the heater-A/C housing and feed the blower motor wire harness connector through the grommet hole in the dash panel side of the housing.
  4. Pull the blower motor wiring through the hole from the dash panel side of the heater-A/C housing until the grommet is seated, while positioning the blower motor and blower wheel assembly inside the housing.
  5. Install the three screws that secure the blower motor, air spoiler, and wheel assembly to the heater-A/C housing. Tighten the screws to 2.2 N·m (20 in. lbs.)
  6. Assemble and install the heater-A/C housing. See Heater-A/C Housing in the Removal and Installation section of this group for the procedures.

Related Dodge Questions