How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Z. Your Own Question
Ron Z.
Ron Z., - Dodge Tech -
Category: Dodge
Satisfied Customers: 17791
Experience:  18+yrs experience. State Inspector and Dodge Diagnostics
Type Your Dodge Question Here...
Ron Z. is online now
A new question is answered every 9 seconds

how to replace the oil pressure switch on a dodge neon 2003

Resolved Question:

how to replace the oil pressure switch on a dodge neon 2003 sxt.
Submitted: 7 years ago.
Category: Dodge
Expert:  Ron Z. replied 7 years ago.


  • Raise vehicle.
  • Position oil collecting container under pressure switch location
  • Disconnect oil pressure switch electrical connector and remove switch


  • Install oil pressure switch and connect electrical connector
  • Lower vehicle.
  • Start engine and allow to run a minimum of 2 minutes.
  • Shut engine off and check engine oil level. Adjust level as necessary.


    Customer: replied 7 years ago.

    Is the switch on the drivers side? Thanks for the help.

    Expert:  Ron Z. replied 7 years ago.
    Correct. towards the drivers side. use the pic to assit in location.
    Ron Z. and 6 other Dodge Specialists are ready to help you