How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask quickcar Your Own Question
quickcar, ASE Certified Technician
Category: Dodge
Satisfied Customers: 1695
Experience:  10+ years chrysler
Type Your Dodge Question Here...
quickcar is online now
A new question is answered every 9 seconds

how do you replace the front crank seal on a 89 dodge caravan

Customer Question

how do you replace the front crank seal on a 89 dodge caravan 3.0
Submitted: 7 years ago.
Category: Dodge
Expert:  quickcar replied 7 years ago.
3.0L Engines
Timing belt covers-3.0L engines

Timing belt covers-3.0L engines

Click to Enlarge
  1. Disconnect the negative battery cable.

  2. Remove the accessory drive belts.

  3. Remove the air conditioner compressor mounting bracket bolts and lay compressor aside.

  4. Remove the air conditioner mounting bracket and adjustable drive belt tensioner from engine.

  5. Remove the steering pump/alternator belt tensioner mounting bolt and remove belt tensioner.

  6. Remove the power steering pump mounting bracket bolts, rear support locknut and set power steering pump aside.

  7. Raise the vehicle and support on jackstands.

  8. Remove the right inner splash shield.

  9. Remove the crankshaft drive pulley bolt, drive pulley and torsional damper.

  10. Lower the vehicle and place a floor jack under the engine. Separate engine mount insulator from engine mount bracket.

  11. Raise the engine slightly and remove engine mount bracket.

  12. Remove the timing belt covers.

To install:

  1. Install the timing belt covers and tighten all screws to 10 ft. lbs. (14 Nm).

  2. Raise the engine slightly and install engine mount bracket.

  3. Install the engine mount insulator into engine mount bracket.

  4. Install the torsional damper, drive pulley and drive pulley bolt. Tighten bolt to 150 ft. lbs. (205 Nm). Install the right inner splash shield.

  5. Install the power steering mounting bracket and install the power steering pump.

  6. Install the steering pump/alternator belt tensioner.

  7. Install the air conditioner adjustable drive belt tensioner and mounting bracket.

  8. Install the air conditioner compressor.

  9. Install the accessory drive belts.

  10. Connect the negative battery cable.

Related Dodge Questions