How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mike Kellam Your Own Question
Mike Kellam
Mike Kellam, ASE Certified Technician
Category: Dodge
Satisfied Customers: 199
Experience:  ASE Master Certified w/ L1 Advanced Eng. Performance, Chrysler Gold Certified, Viper Specialist
Type Your Dodge Question Here...
Mike Kellam is online now
A new question is answered every 9 seconds

How do you remove cd player radio out of 2003 Dodge Ram 3500 Series

Customer Question

How do you remove cd player radio out of 2003 Dodge Ram 3500 Series
Submitted: 7 years ago.
Category: Dodge
Expert:  Mike Kellam replied 7 years ago.

The center-stack Bezel around the radio/heater controls snaps-out of place easily. Remove the 4 screws from the radio bezel and slide the radio out. Disconnect the harness connectors on the rear of the radio, and you are done. Installation is the reverse of removal.
Customer: replied 7 years ago.
We need more instructions about how to remove the bezel because we are afraid we are going to break it as it won't snap out easily. There is also a woodgrain panel around the radio and heater. Is that what you are calling the bezel?
Expert:  Mike Kellam replied 7 years ago.

Sorry for the delay in reply. I double checked the disassembly procedure and it is as follows:


The Woodgrain trim is the bezel. You need to remove the lower knee-blocker panel (below the column) and remove screws from the left side. On the right side, open the glove box, and remove 2 screws. In the recess of the bag hook on the right side of the bezel, remove one more screw. At this point you should be able to pull the bezel assembly away from the dash. It snaps in tightly, and can be a little tough to dislodge the clips, but no damage should occur. Just make sure to pull the bezel straight away from the dash.