How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jerry Your Own Question
Jerry, Master Mechanic
Category: Dodge
Satisfied Customers: 16826
Experience:  ASE Master tech, 30 years exp. troubleshooter, driveability tech
Type Your Dodge Question Here...
Jerry is online now
A new question is answered every 9 seconds

Car diagram of a bushing that the Mech..whole car

This answer was rated:

1996 Interpid. Looking for a proper name or under car diagram of a bushing that the Mech called a "subframe" bushing. There are 4 of them and they are big and look like they hold the whole car on the "main frame"

Hello and welcome to Just, Super mechanic here. About your vehicle.


Here are the proper names along with the factory part numbers from a service bulletin about them, thanks



NO: 13-01-97

GROUP: Frame

EFFECTIVE DATE: Jun. 13, 1997


Popping, Oil Canning
or Metallic Noise From
Front of Vehicle



1996 - 1997 (LH) Concorde/Intrepid/Vision/LHS/New Yorker


Popping, oil canning or metallic sounding noise from front area of vehicle when accelerating from a stop. Noise most noticeable in high ambient temperatures (90°F. or higher).


Moderately accelerate vehicle and listen for noise from passenger toe board area. If noise is present, perform the Repair Procedure.



AR (2) 04695176 Isolator, Cradle Mounting, SDC Suspension, Upper

AR (2) 04582973 Isolator, Cradle Mounting, SDC Suspension, Lower

AR (2) 04582972 Isolator, Cradle Mounting, SDE Suspension, Upper

AR (2) 04582974 Isolator, Cradle Mounting, SDE Suspension, Lower



This bulletin involves installing 2 new upper and 2 new lower cradle mounting isolators.

1.Raise vehicle on a suitable hoist.


2.Support engine/transaxle cradle with jack stands.


3.Loosen cradle mounting bolts (4).


4.Remove cradle mounting bolts one at a time and replace cradle mounting isolator.


5.Tighten cradle mounting bolts to 155 Nm (115 ft.lbs.).


6.Lower vehicle, verify condition is repaired.


POLICY: Reimbursable within the provisions of the warranty.


Labor Operation No: 13-30-06-90 0.7 Hrs.



Jerry and 2 other Dodge Specialists are ready to help you
Customer: replied 8 years ago.
Do you have a photo or diagram so I can be sure that we are talking about the same thing?

I don't have a picture of the insulators themselves however, you can see where one of them are in this picture. It is on the far left side, at the front of the frame.





Related Dodge Questions