How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 22280
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
9825021
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

How do you replace the vacuum actuator switch motor on a 95

This answer was rated:

How do you replace the vacuum actuator switch motor on a 95 dodge ram 4x4 located on the front differential

AXLE SHIFT MOTOR

REMOVAL

  1. Disconnect the vacuum and wiring connector from the shift housing.
  2. Remove indicator switch.
  3. Remove the shift motor housing cover, gasket and shield from the housing
  4. To replace the motor, remove c clips from shaft, slide motor from disconnect housing

INSTALLATION

  1. Install the shift motor housing gasket and cover. Ensure the shift fork is correctly guided into the shift collar groove.
  2. Install the shift motor housing shield and attaching bolts. Tighten the bolts to 11 N·m (96 in. lbs.) torque.
  3. Add 148 ml (5 ounces) of API grade GL 5 hypoid gear lubricant to the shift motor housing. Add lubricant through indicator switch mounting hole.
  4. Install indicator switch, electrical connector and vacuum harness.

graphic

sprinkles08 and 7 other Dodge Specialists are ready to help you
Customer: replied 8 years ago.
very quick and acurate answer

You are welcome. Thank you and good luck!

sprinkles08 and 7 other Dodge Specialists are ready to help you