How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Kevin Your Own Question
Kevin
Kevin, Dodge Technician
Category: Dodge
Satisfied Customers: 752
Experience:  15 years working at a Chrysler dealer Master Tech Owner Of Kevins Mobile Repair Atlanta
10592253
Type Your Dodge Question Here...
Kevin is online now
A new question is answered every 9 seconds

05 srt4; how do i drain/ refill transmission and with ...

This answer was rated:

05 srt4; how do i drain/ refill transmission and with what type of fluid?        thanks
chrysler dont have a drain and refill u will need to drop the pan and replace the filter and new RTV gasket.
Customer: replied 8 years ago.
Reply to Kevin's Post: this car has a 5speed gearbox so it dont have a pan. the owners manual says to change the manual transaxle fluid every 30,000 miles, i dont see a pan or a fill plug.
ahhh thats different one sec

STANDARD PROCEDURE - FLUID DRAIN AND FILL

NOTE: The fluid required in this transaxle is Mopar® ATF+4 (Automatic Transmission Fluid—Type 9602).

All T350 transaxles are equipped with a fill plug. The fill plug is located on the left side of the transaxle differential area(Fill Plug Location). The fluid level should be within 3/16 inch from the bottom of the transaxle fill hole (vehicle must be level when checking).

All T350 transaxles are equipped with a drain plug. The drain plug is located on the lower right side of the transaxle differential housing (Drain Plug Location). Tighten drain plug to 28 N·m (250 in. lbs.)

Fill transaxle to capacity. Refer to following chart. Wipe the outside of the transaxle if any lubricant spills.

NV T350 MANUAL TRANSAXLE FLUID FILL

TRANSAXLE METRIC MEASURE U.S. MEASURE
NV T350 2.4-2.7 Liters 2.5-2.8 Quarts



graphic



STANDARD PROCEDURE - FLUID DRAIN AND FILL

NOTE: For proper fluid change intervals, (Refer to LUBRICATION & MAINTENANCE/MAINTENANCE SCHEDULES - DESCRIPTION)

The fluid required in this transaxle is Mopar® ATF+4 along with 0.12L (4 oz.) Mopar Limited Slip Additive/Friction Modifier (P/N 04318060AB). Use of substitute fluids may result in improper transaxle operation, noise and/or failure.

FLUID DRAIN

  1. Raise vehicle on hoist.
  2. Remove transaxle drain plug (Transaxle Drain Plug) and drain fluid into suitable container.
  3. Install drain plug and torque to 23 N·m (17 ft. lbs.).

FLUID FILL

  1. Remove transaxle fill plug (Transaxle Fill Plug).
  2. Add 0.12L (4 oz.) Mopar® Limited Slip Additive/Fricion Modifier (P/N 04318060AB) and up to 2.3-2.5L (2.4-2.6 qts.) of Mopar® ATF+4 until fluid is within 3/16” below fill hole.
  3. Install fill plug, ensuring it is properly seated.
  4. Lower vehicle.

Kevin and 7 other Dodge Specialists are ready to help you