How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask TIM Your Own Question
TIM
TIM, SERVICE MANAGER
Category: Dodge
Satisfied Customers: 6177
Experience:  DODGE SERVICE MANAGER- 20 + YEARS
6531745
Type Your Dodge Question Here...
TIM is online now
A new question is answered every 9 seconds

How to replace a wheel hub on a 2002 Dodge Ram 1500 4x4.

This answer was rated:

No Comment Added
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the brake caliper and rotor
  4. Remove the ABS wheel speed sensor if equipped,
  5. Remove the halfshaft nut.

    .

  6. Remove the tie rod end nut and separate the tie rod from the knuckle using special tool 8677.
  7. Remove the upper ball joint nut and separate the upper ball joint from the knuckle using special tool 8677.
  8. Pull down on the steering knuckle to separate the halfshaft from the hub/bearing.
  9. Remove the three hub/bearing mounting bolts from the steering knuckle (
  10. Slide the hub/bearing out of the steering knuckle
  11. Remove the brake dust shield.

1 - HUB/BEARING MOUNTING NUTS
2 - HALF SHAFT

TIM and other Dodge Specialists are ready to help you
1 - WHEEL SPEED SENSOR MOUNTING BOLT
2 - WHEEL SPEED SENSOR
3 - HUB/BEARING

Related Dodge Questions