How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask TIM Your Own Question
TIM
TIM, SERVICE MANAGER
Category: Dodge
Satisfied Customers: 6177
Experience:  DODGE SERVICE MANAGER- 20 + YEARS
6531745
Type Your Dodge Question Here...
TIM is online now
A new question is answered every 9 seconds

how to change the starter on a 97 intrepid

Customer Question

No Comment Added
Submitted: 9 years ago.
Category: Dodge
Expert:  TIM replied 9 years ago.

STARTER

3.3L ENGINE

REMOVAL

  1. Disconnect battery negative cable
  2. Raise vehicle.
  3. For easier servicing, do not remove the wiring from starter at this time.
  4. Remove three starter attaching bolts from engine/transaxle
  5. Remove starter assembly from transmission housing. Position the starter to gain access to the wiring connectors.
  6. Remove the battery positive cable nut from starter and remove the cable
  7. Disconnect push on solenoid connector.
  8. Remove the starter from vehicle.

INSTALLATION

For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.

3.5L ENGINE

REMOVAL

  1. Disconnect battery negative cable
  2. Raise vehicle.
  3. For easier servicing, do not remove the wiring from starter at this time.
  4. Remove three bolts attaching starter to engine
  5. Remove starter solenoid assembly from transmission housing. Position the starter to gain access to the wiring connectors.
  6. Remove the battery positive cable nut from starter and remove cable
  7. Disconnect push on solenoid connector.
  8. Remove the starter from vehicle.

INSTALLATION

For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid