How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask dugan50 Your Own Question
dugan50, Technician
Category: Dodge
Satisfied Customers: 60
Experience:  35 yrs experienced shop owner / technician
Type Your Dodge Question Here...
dugan50 is online now
A new question is answered every 9 seconds

No Comment Added

Customer Question

No Comment Added
Submitted: 9 years ago.
Category: Dodge
Expert:  dugan50 replied 9 years ago.
Hi there:
Here is a trouble code chart for you to use. Code 13 requires the replacement of the TCM. I am also giving you instructions and a picture of how to do that.
I hope I have helped you. Good luck.


  1. Remove speed control servo (three fasteners).
  2. Remove windshield washer reservoir fill tube fastener.
  3. Remove one nut and screw holding transmission control module bracket to vehicle.
  4. Lift control module and bracket to gain access to 60-way connector.
  5. Loosen 60-way connector retaining screw, located in the center of the 60 way connector. Then disconnect the 60-way connector on transmission control module.
  6. Remove transmission control module mounting screws and lift module from vehicle.


  1. Install transmission control module and tighten mounting screws.
  2. Install 60 way connector. Tighten 60 way retaining screw to 4 Nm (35 inch lbs.) .
  3. Install one nut and screw holding transmission control module bracket to vehicle.
  4. Install windshield washer reservoir fill tube fastener.
  5. Install speed control servo (three fasteners).

Related Dodge Questions