How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Cat Man Your Own Question
Cat Man
Cat Man, Cat Engine Expert
Category: Construction and Road Equipment
Satisfied Customers: 8348
Experience:  I am ASE Master Certified.
Type Your Construction and Road Equipment Question Here...
Cat Man is online now
A new question is answered every 9 seconds

I have a c15 acert with fault code 32 I replaced the tps but

Customer Question

I have a c15 acert with fault code 32 I replaced the tps but the engine idles but doesn't respond to the pedal I tested the 3 pin connectors with a lectures of 8.0. 13.5. And ground. What could have been the problem?
Submitted: 3 months ago.
Category: Construction and Road Equipment
Expert:  Cat Man replied 3 months ago.
Thanks for asking your question. I will try and help you out.
There are only 3 things that can cause a code 32.
First and most common is a faulty TPS. Which you have already replaced.
Second is a problem in the wiring. Pin a is an 8 volt supply. B is the ground. And C is the signal wire.
Lastly is a faulty ECM. This is very rare.
I would try running new wires from the TPS to the ECM. If the problem continues. The ECM is all that's left.
Please reply back if you need more help or have more questions. I am happy to assist.

Related Construction and Road Equipment Questions