my bl70 has been run out of fuel. I need to find out the bleeding procedure
Already Tried: Have filled the machine and pumped the primer with the drain on the filter open and with key on I pumped the primer and tried starting it. have done this 4 or 5 times and no luck. there are white plugs beside the injector lines that look like there may be a bleeding valve in there or something.
Hi I will help with your problem Please do not rate until all your questions are answered that way you wont have to pay twice Use reply to expert link.First thing to do is remove your filter and fill all the way with fresh fuel and put back on,then loosen the fuel lines at the cylinder head 1 turn,make sure you tighten drain on filter,then pump your hand primer up until you have fuel coming out lines at head,don't worry all of them won't get fuel, keep pumping and tighten only the lines that have fuel coming out,then crank engine over and it will begin to start and other fuel lines will start to bleed tighten down as they get fuel,it should be running now.If not there is another issue,we can go over if it does not start.It is a good idea to have a battery charger on unit while cranking you don't want to burn up starter from a low battery.