How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Russell H. Your Own Question

Russell H.
Russell H., Internet and LAN
Category: Networking
Satisfied Customers: 9520
Experience:  11 years work with Internet/IP, routers, networks, servers
13568747
Type Your Networking Question Here...
Russell H. is online now
A new question is answered every 9 seconds

15.10 bridge ip is seen by going to a server website not the

Customer Question

15.10 bridge ip is seen by going to a server website not the ip of the visitorThis is a xen bridge issue. I have a web server guest. When people click on a web page, the apache logs show the IP of the bridge, not the persons IP who clicked on the page. The bridge should be transparent (and is on my older Debian configuration)I have a pretty strait forward set up, or at least I think I do. Any ideas why my guest web server logs are not seeing the users IP? What would be the typical cause?Thanks all.# ***** how to activate them. For more information, see interfaces(5).source /etc/network/interfaces.d/*# ***** loopback network interface
auto lo xenbr0 xenbr1
iface lo inet loopback# ***** primary network interfaceiface xenbr0 inet staticbridge_ports p6p1
address 74.xxx.xxx.5
netmask 255.255.255.240
gateway 74.xxx.xxx.14
bridge_stp off
dns-nameservers 68.xxx.xxx.146 68.xxx.xxx.98iface xenbr1 inet static
bridge_ports eth1
bridge_stp offaddress 192.168.1.1
netmask 255.255.255.0post-up ethtool --offload p6p1 gso off tso off sg off gro off
post-up ethtool --offload eth1 gso off tso off sg off gro offbridge name bridge id STP enabled interfaces
xenbr0 8000.00a0244d1fbe no p6p1
vif2.0
vif7.0
vif8.0
xenbr1 8000.feffffffffff no vif1.0
vif2.1
vif7.1
vif8.1
vif9.0
Submitted: 7 months ago.
Category: Networking
Expert:  Russell H. replied 7 months ago.
Hi, thank you for contacting JustAnswer.com. My name is***** will do what I can to provide the right answer to your question.Your setup is obvious routing rather than briding/forwarding, or some such. Indications are that you need wds in your configuration. (? unless that's only for a wireless transparent bridge.) But I cannot find specifics. You must be doing something very basic wrong, in building a transparent bridge, or something very subtle... I cannot tell which at this point, to be honest.