How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gary Your Own Question
Gary
Gary, ASE Certified Technician
Category: Classic Car
Satisfied Customers: 949
Experience:  Senior Technician
84449473
Type Your Classic Car Question Here...
Gary is online now
A new question is answered every 9 seconds

I have a 350 4 bolt main bored 60 over the crank is 10 on

Customer Question

I have a 350 4 bolt main bored 60 over the crank is 10 on mains and20 on rods I have a set of botie angle plug heads with double springs with dampers the heads are 56cc and the pistions are forged 11.1
Submitted: 11 months ago.
Category: Classic Car
Expert:  Gary replied 11 months ago.

Hello Kenny,

What camshaft specs?

The engine is getting for 3500 rpm from somewhere, have you got an unused vacuum source not capped?

What have you set the throttle blades open at?

Double pumper 4 corner idle carbs should have the transfer slots just exposed as a "square" to start with.

Have you run the camshaft in?

How much total run time has it had?

Gary

Expert:  Gary replied 11 months ago.

Hello Kenny,

Have you had any success with your car problem?

I hope my advice has been of assistance to you.

Kind regards

Gary

Related Classic Car Questions