1956 ford country sedanI have replaced the headlight switch, but still no low beams. I presume it's the dimmer switch. How is the dimmer switch removed? After removing the two mounting screws, I can't figure out how to remove the switch?
Country: United StatesMake: FordModel: COUNTRY SEDANYear: 1956Engine: 351C
Thanks for using J/A / PearlMy answer is below. "Please only rate my answer if you are satisfied with the service I have provided. If you feel the need to rate "Poor Service" or "Bad Service", please stop and reply to me via the REPLY TO EXPERT button with the issue you have, because this will result in a negative mark on my feedback record. I will be happy to continue further and do everything I can to provide you with the service you seek.Instead, please simply reply to me via the REPLY TO EXPERT link with the issue you have. I am happy to continue further and do everything I can to provide you with the service you seek."My answer may not be to your liking, but is a correct & honest answer.Many times the only fix will be by Dealer or Shop, so please do not hold that against me.
How is the dimmer switch removed? After removing the two mounting screws, I can't figure out how to remove the switch?
If you have removed the Screws, then the Switch is pushed down thru Floor, by FrameLikely stuck due to years of grime & / or Tar type substance used for sealingShould be "3" connections on it that you can "short" accross to see if the Switch is bad or wires
You can also find these On-Line or E-Bay if it is bad
If you need further, please let me know "BEFORE" you Rate my Answer.............
Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.