How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chad Farhat Your Own Question
Chad Farhat
Chad Farhat, ASE Certified Technician A6 - Electrical / Electronic systems
Category: Chrysler
Satisfied Customers: 2580
Experience:  Owner at Carolina Auto Service & Sales , 20 years Experience in Foreign & Domestic Vehicles .
45790705
Type Your Chrysler Question Here...
Chad Farhat is online now
A new question is answered every 9 seconds

I have a 2006 Crossfire standard trans. The door locks

Customer Question

I have a 2006 Crossfire standard trans. The door locks stopped working, than it wouldn't start. Id turn the key and it would fire and quickly sputter off. Next it started and ran. The next time I statrted it sputtered off again 4 times in a row, then would npt even crank, just nothing. Any help/suggstions?
Thanks, ***** ***** TN
Submitted: 4 months ago.
Category: Chrysler
Expert:  Chad Farhat replied 4 months ago.

Hi, I'm Chad. Welcome to JustAnswer. I'm reviewing your question and I will be posting your reply ASAP.

Expert:  Chad Farhat replied 4 months ago.

hey how are you

1- do we have 12 volt on battery

2- is there any red security light on dash flashing or steady on

3-fuel pressure checked ?

Master reset Procedure

1- Disconnect Battery Cables ( Negative & Positive Cables )you can use any electrical wire as an extension if battery cables don't reach .

2- Hold cables Together for 60 secs ,then let go

3- Wait 15 minutes

4- Make sure all doors are closed

5- Reconnect battery Cables

6- Lock & unlock the vehicles using the key from driver door side (if you have a key fob with no blade key, just lock & unlock using the key fob buttons)

7- Enter the vehicle and attempt to start

Please let me know

Thank You

Chad Farhat

ASE Certified Technician

Customer: replied 4 months ago.
1. yes battery at 12 to 14 v
#2. No red lights, or any remain on.
#.3. I dont have a way to check fuel pressure.
Master reset procedure will have to wait until it stops raining, car is on the driveway.
Expert:  Chad Farhat replied 4 months ago.

ok i got you , rain started here too :)

ok sounds good, i m online from 10 am till late daily , so just let me know

Chad

Expert:  Chad Farhat replied 4 months ago.

Please let me know if you need anything else on it, just reply back and we will continue

If you are good, Please Kindly Rate Me.

A 5 Star Rating is much Appreciated

If you feel I have not been helpful Please DO NOT RATE ME BAD OR POOR (1 or 2 stars) ,You can always ask me again or I can opt out of your question & open it for another expert ,that will provide you with more or better assistance on this issue

Please keep in mind that when you rate me , it does not end our conversation.

you can always come back to this conversation and ask me any follow up question you may have on this issue

(you can copy this link page & paste it in your browser when ready and it will open up our conversation again)

Thank You
Chad Farhat
ASE Certified Technician

Expert:  Chad Farhat replied 3 months ago.

Hey how are you

Just checking on you to see if you got it resolved or you like additional help on it

Thank You

Chad