How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 21413
Experience:  ASE Master & Advanced level certified, Chrysler Master Certified, Trans and Hybrid Specialist
Type Your Chrysler Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

I have chrysler 300c srt8 and code C2116 i replaced the abs

Customer Question

Hi, i have chrysler 300c srt8 and code C2116 i replaced the abs motor but still the code coming up so i checked the harness cable to the abs the is no power on pin1 and pin4 so what to do ?
JA: Is the power loss consistent, or does it fluctuate?
Customer: consistent
JA: What year is your SRT-8?
Customer: 2006
JA: Are you fixing your SRT-8 yourself? What have you tried so far?
Customer: yes by my self i checked the fuse and other pins as 8 and 32
JA: Anything else you want the mechanic to know before I connect you?
Customer: no thank you just that
Submitted: 28 days ago.
Category: Chrysler
Expert:  david craig replied 28 days ago.

Hi Im David, thanks for visiting the site. allow me to pull up a print for you.

Expert:  david craig replied 28 days ago.

you need to check fuse 21 in the ipm.

Customer: replied 28 days ago.
ok now i have power on pin 1 and the c2116 code has gone but another one has come c107c and c107d i replaced the brake pedal switch and same codes showing up
Expert:  david craig replied 28 days ago.

ok. gimme a few

Expert:  sprinkles08 replied 25 days ago.

Hello and welcome to JustAnswer!

These codes set when there is a correlation issue between the two switches in the brake switch. Tihs could be the switch, wiring or the ABS module.

Was the switch adjusted after it was installed?
Have you monitored the state of both brake switches with a scan tool?