How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 21417
Experience:  ASE Master & Advanced level certified, Chrysler Master Certified, Trans and Hybrid Specialist
Type Your Chrysler Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

On load it opens up the asd fuse. #5, I dont have it, 93

Customer Question

On load it opens up the asd fuse. #5
JA: Have you checked the vehicle's manual yet?
Customer: I dont have it
JA: What is the model/year of your Chrysler?
Customer: 93 cirrus
JA: What year is your Cirrus?
Customer: 93
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: Ive checked the asd relay, injectors, coil, and egr valve connection.
JA: Anything else you think the mechanic should know?
Customer: Just while it is running it doesbt blow the fuse and I powerbraked it just to see if it would open the fuse and exactly what i thought it did.
Submitted: 2 months ago.
Category: Chrysler
Expert:  sprinkles08 replied 2 months ago.

Hello and welcome to JustAnswer!

If the ASD fuse is blowing it's because of high current draw on the circuit. It could be blowing due to excessive dwell which is being aggravated or it could be blowing because of a short to ground in the harness. Its likely that the harness is moving enough under acceleration that a damaged spot n the ASD wire is shorting to ground.

Do you have the VIN?

Customer: replied 2 months ago.
Customer: replied 2 months ago.
I just tried it today again it just blows the fuse soon as I open the ignition on.
Has anyone had the same situation before?
Expert:  sprinkles08 replied 2 months ago.

You have a 1996 Cirrus with a 2.4.

If the fuse is blowing without the engine even running then you definitely have a short to ground in the harness. The most common place for issues was at the back of the engine block area.

Customer: replied 2 months ago.
But what component or wire?
Because I wiggled around underneath the fuse block and the car would turn off while running then I would wiggle it around more and it would start up. You could hear the transmission module getting power. Could it be somewhere there?
Expert:  sprinkles08 replied 2 months ago.

The ASD circuit. It's the dark green/orange wire that powers the injectors, coil, and oxygen sensor heaters.

Related Chrysler Questions