Chrysler Repair Questions? Ask a Mechanic for Answers ASAP
If the car's not cranking then first check it can turned over by hand so double checking for any mechanical issues
If OK then check that the main battery cables are on tight and the terminals are clean and bright. Do the same for the engine / gearbox earth strap.Then follow the main positive lead back to the engine and down to the starter motor, and check the connection at this end as well.
There should also be a small wire to the motor which should have 12V when you're turning the ignition switch to crank. If the 12V isn't there, check back along this wire for damage to the insulation or corroded connections
This 12V feed comes directly from the ignition switch so this may be faulty and need replacing
Check the resistance of the main positive lead that runs down to the motor as anything more than a few ohms and it should be replaced
Don't forget to try a jump start from another car / battery as its possible the battery is poor, if you have a voltmeter a healthy battery should read 12.7+V
one other thing to consider is that the immobiliser is faulty and preventing the starter from being enabled - however if the dash / ignition lights are on then this usually means that its off
do you still need help?
Bear in mind that the site takes a deposit from you at the beginning andthis is held by the site until you rate my answer at which point the cash issplit between the site and the expert. I am only paid for my work on thisquestion if you rate my answer, using the star system at the top of the screen. Please do not forget! Thank you