How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Aftermarket & Factory Electronics
Category: Chrysler
Satisfied Customers: 504
Experience:  Cert. Chrysler Warnty, Heavy Line Mech, Mobile Electronics. Sales, Installation & Repair for 30 years
Type Your Chrysler Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

How do you change low pressure Ac line, 2006 Put : PT

Customer Question

How do you change low pressure Ac line, 2006 Put
JA: How is the air flow? Have you checked the hoses?
Customer: PT cruiser
JA: Tell me a bit more about what's going on so he can help you best.
Customer: No leaks, dye in system, acts as if orifice tube clogged
JA: Are you hoping to fix this yourself?
Customer: Yes
JA: Great! What have you tried so far?
Customer: Looking for access to bottom of condenser, to remove line
JA: Is there anything else the Chrysler Mechanic should be aware of about your Chrysler?
Customer: No i don't think so, car only has 101,xxx miles
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Chrysler Mechanic about your situation and then connect you two.
Submitted: 4 months ago.
Category: Chrysler
Expert:  camerontech replied 4 months ago.

hi there,

im cam, a licenced diagnostic tech and a 20 year ac tech.
have you checked or replaced your expansion valve in your system?

this is the item that controls your flow to your evap core and converts the high pressure to low.

these are a high failure rate

the only reason to replace the suction line is if it is leaking

Expert:  camerontech replied 4 months ago.

as for your low pressure lines question.

there are no low pressure lines that connect to the condensor.

there is a discharge line that goes from the compressor to the condensor and then there is the liquid line that goes from the condensor to the expansion block valve.

if this is the line you are talking about replacing than you must remove the upper rad support to access it.

even with this removed, it will be tight as there is not much room to work in when it comes to pt cruisers, as im sure youve found out.

there is no orfice tube inline with this liquid line. these do not use this type of system

Related Chrysler Questions