How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tim's Auto Repair Your Own Question
Tim's Auto Repair
Tim's Auto Repair, Mechanic
Category: Chrysler
Satisfied Customers: 15465
Experience:  Have owned a repair shop for 25 yrs.
14541291
Type Your Chrysler Question Here...
Tim's Auto Repair is online now
A new question is answered every 9 seconds

Have a 2000 Chreysler Cirrus that will not start. When the

Customer Question

Have a 2000 Chreysler Cirrus that will not start. When the problem started it was being driven on the freeway and car started to spit and sputter. Once car was pulled over to the side of the road it would not start back up. Replace fuel pump, fuel filter, battery, spark plugs, coil, plug wires, crankshaft sensor, cam shaft sensor, and ecm. Car still will not start. It won't fire off ether but has spark. No codes are being produced either. Doesn't sound normal when cranking over but is still cranking. Any idea where I can check from here?
Submitted: 1 year ago.
Category: Chrysler
Expert:  Jerry replied 1 year ago.

Hello and welcome. My name is ***** ***** you for visiting the site, I will be happy to assist you today.

.

What is the compression? Timing belt good?

Customer: replied 1 year ago.
The timing belt seems to be good aswell as compression
Customer: replied 1 year ago.
There is also 50lbs fuel pressure at the rail
Expert:  Jerry replied 1 year ago.

I see, thanks. Do the marks "seem to be" lined up?

.

Also what is the compression, in PSI?

Customer: replied 1 year ago.
160-170 on all four cylinders and yes the timing marks are lined up. The belt has been replaced recent but before I obtained the vehicle.
Expert:  Jerry replied 1 year ago.

Fuel spark and compression it should start.

I will opt out and open it back up. Please DON’T REPLY to this post as that will lock the question back to me, also DON’T RATE THE ANSWER yet, someone should be along shortly, I’m sure, thanks and sorry I wasn’t able to help with it.

.

*******YOU CAN ALWAYS GET A REFUND WITHOUT RATING THE ANSWER AS BAD OR THE SERVICE AS POOR ********

Expert:  Tim's Auto Repair replied 1 year ago.

Hi, My name is ***** ***** for the delay.

I will do my best to assist you

do you get any trouble codes?if so,can you give me the code#'s?

will it fire with a prime?[a little starting fluid or some fuel into the throttle body]?

Customer: replied 1 year ago.
No codes and it will not fire off starting fluid which I find odd since there is spark
Expert:  Tim's Auto Repair replied 1 year ago.

are you sure the belt is in time?

Related Chrysler Questions