How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tim Mohr Your Own Question
Tim Mohr
Tim Mohr, ASE MASTER TECH
Category: Chrysler
Satisfied Customers: 15121
Experience:  30 YRS EXPERIANCE, AUTO AND TRUCK,FOREIGN AND DOMESTIC, GAS AND DEISEL
17454363
Type Your Chrysler Question Here...
Tim Mohr is online now
A new question is answered every 9 seconds

Chrysler 300 c: I replace the radiator . I need to bleed the

Customer Question

I replace the radiator .
I need to bleed the cooling system in my car a 300 c 2005
Submitted: 1 year ago.
Category: Chrysler
Expert:  Mike S. replied 1 year ago.
Does that cooling system have the cap on the radiator? Also, is there no bleeder?
Expert:  Mike S. replied 1 year ago.
If you answered yes and no, Let the engine warm up, with heater set on hot and with the cap off, untill the thermostat opens up then shut the engine off. Now jackup under the frame under the front on the same side as the radiator cap untill the cap hole is higher than the rest of the cooling system. Now top off the fluid, then go around to the top radiator hose and grab it with both hands and push the hose down as far as it will go and then squeeze real hard with both hands and push any air out the cap hole. Lower the vehicle, start the engine and allow the thermostat to open again, then top off the coolant.
Customer: replied 1 year ago.
The cap is not on the radiator.
Expert:  Mike S. replied 1 year ago.
I'll opt out hen cause I don't know off hand how they bleed.
Expert:  Tim Mohr replied 1 year ago.
Hi, my name is ***** ***** you still need help with this?