When the Check Engine Light comes on, this is NOT a reminder to have service done, the on-board computer sees a problem. If the Mechanic "did something" and the light went off, all he did was "clear" the codes from the computer. Once you have driven a few miles, the light WILL return, as the "problem" was not addressed. It takes some miles for the light to return, because after a "code clear" the on-board computer needs to "reboot" and re-check all the parts/sensors in all the systems until the original problem is re-found, or a new problem arises.

When the Check Engine light comes on, this is the on-board computer's way of telling you it sees a problem in one of the monitored systems. Unfortunately, there are literally 100's of parts and sensors monitored in various systems, and to take a "guess" as to which part/sensor in which system is faulty, is virtually impossible. However, if you are not experiencing any drivability issues such as skipping, stalling, shifting problems, etc, then more than likely, the problem is going to lie in the EVAP (emissions) system. Very commonly, this could be a faulty, loose or missing fuel cap or even putting fuel in while the vehicle is running. Check the cap for any cracks in the rubber o-ring on the underside. Check the fuel filler neck for any signs of chips or debris. Check under the vehicle, around the area of the fuel tank and the EVAP canister looking for any vacuum lines that have dry-rot cracks, holes or loose/missing connections. If these all check out, then the best thing to do at this point is to have the "p-codes" read from the on-board computer. These p-codes are what is used as a "starting point" for the diagnosis and will tell which part/sensor in which system has the fault. There isn't a Mechanic on the planet that can tell you what is wrong with the vehicle just by "looking" at the Engine Light. Every single Mechanic's first course of action WILL be to obtain the p-codes. Once you get these p-codes you can more accurately and efficiently diagnose the problem and then make the repair. You can have these p-codes read FREE (except in California) at any local "big chain" part store (ie. AutoZone, PepBoys, Advanced, etc). If you still need help after retrieving the codes, you can bring them here, and any of our Techs can walk you through the diagnostic procedure, and then even help you make the repair if you feel confident enough to try.