Chrysler

Ask a Chrysler Question, Get an Answer ASAP!

gt: Le..Turbo..1989 is leeking in the heating system..comming..heater

Answered by:SuperDave
ASE Certified Technician
Positive Feedback: 100.0 %
Accepted Answers: 68

in Chrysler

Recent Feedback

Positive

Thanks for the quick response!

Customer Question

my Le baron Turbo gt from 1989 is leeking in the heating system inside in the car. Hot ( Steam ) i comming into the windows. I thougt i must remove the heater from the car and maybe find out where the leeking . What is the way to do that

Country: Norway
Make: Chrysler
Model: le baron gt turbo
Year: 1989

Already Tried:
I tried to remove the heating instrument in the car but i cold not find out how to find and remove the heater inside the car

Submitted: 352 days and 17 hours ago.

Category: Chrysler

Value: kr 248

Status: CLOSED

Accepted Answer

Expert: SuperDave replied 352 days and 17 hours ago.

This is how to remove the heater core:

From inside the engine compartment, disconnect negative battery cable.

Discharge A/C refrigerant and disconnect lines at A/C unit.

Drain radiator and disconnect heater hoses at A/C unit. Tape heater tubes to keep from leaking during removal.

Remove A/C condensate drain and disconnect vacuum lines.

Inside passenger compartment, remove steering column cover.

Position front seat or right front seat full rear.

Remove right cowl side trim.

Remove glove box.

Remove right instrument panel reinforcement.

Remove front and rear consoles.

Remove center distribution and defroster adapter ducts.

Disconnect relay module.

Disconnect blower motor wire connector.

Disconnect demister hose from top of unit.

Disconnect the temperature control cable flag from the bottom of the heater A/C unit and unclip the cable from the left side of the heat distribution duct. Swing the cable out of the way and to the left.

Disconnect the vacuum lines at the unit.

Disconnect right 25-way connector bracket and fuse block from panel.

Remove antenna cable from clip on top of unit.

From engine compartment, remove 4 unit attaching nuts.

Remove unit hanger strap lower screw and rotate strap.

Move heater-A/C unit rearward to clear mounting studs and lower.

While pulling the lower right of instrument panel rearward:

Rotate Unit while pulling from under instrument panel

Remove heater A/C unit top cover.

Remove heater core to dash panel seal from the core tubes and remove the heater core from the unit.

To install, reverse the preceding operation.

Expert Type	ASE Certified Technician
Category:	Chrysler
Pos. Feedback:	100.0 %
Accepts:	68
Answered:	5/5/2012

Experience: over 16 years experience

Ask this Expert a Question >

5 Chrysler Mechanics are Online Right Now

Chrysler Questions	Date Submitted
Chrysler Pacifica: My wifes 2005 chrysler pacificas battery	4/18/2013
Chrysler 300c: my 2005 chrysler 300c has been overheating	4/18/2013
2005 Chrysler 300 Touring	4/18/2013
Chrysler Sebring: What is the vibration noise near the 2001	4/18/2013
Chrysler sebring convertible: I have to do rear brakes on a	4/17/2013
Chrysler PT Cruiser: need labor time to change inner and outer	4/17/2013
Chrysler 300M: was there a 2002 chrysler 300m made without	4/17/2013
Chrysler Grand Voyager LE: We own a 1999 Chrysler Grand Voyager.	4/17/2013
Chrysler 300 Limited: How do I reset my alarm on my Chrysler	4/16/2013
Chrysler Pacifica Touring: Chrysler 2005 Pacifica: I opened	4/16/2013