Recent Feedback
2006 T & C driver side sliding door will pop open, then stop. must be manually opened the rest of the way. Must be manually closed, but will draw door tight .What is the most commen ailment ? What is estimated cost of repair ?
hi i'm billwelcome to just answerplease remember I am NOT there in front of you! my answers are based on your information.
USUALLY this is caused by the wiring harness in the lower portion of the door track, it has a plastic chain covering on it and follows the door,so as time goes and the door is opened and closed hundreds perhaps thousands of times the wires break and the door stops at the point of the break, the fix is replacing the harness.
the diagnosis should cost about an hours labor (YES this must be diagnosed unless you want to guess and throw parts at it which gets very expensive very quick), the installation should be about 1.5 hours labor because there is a connector on the door pillar that must be accessed and the harness must be routed properly this all takes time, the harness was LAST TIME I LOOKED around 100.00 not to say it hasn't gone up and is a dealer only item.
Experience: chrysler master electrical drivability tech 21 years with chrysler corp.