How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George H. Your Own Question
George H.
George H., ASE Master Technician
Category: Chrysler
Satisfied Customers: 18390
Experience:  ASE Master Tech 15+ Years
13574682
Type Your Chrysler Question Here...
George H. is online now
A new question is answered every 9 seconds

Where is the fuse for the heater fan on a 2006 Pacifica ?

Resolved Question:

Where is the fuse for the heater fan on a 2006 Pacifica ?
Submitted: 4 years ago.
Category: Chrysler
Expert:  George H. replied 4 years ago.

Hello I will help you with your question,

 

There is a blower fuse #42 in the integrated power module (fuse block) up front in the engine compartment.

 

The legend should be in the cover for the box.

 

Let me know if you have further questions

 

Thank you

 

 

Customer: replied 4 years ago.
I checked the fuse (its good) but I'm still not getting any power to the heater ...any suggestions ?
Expert:  George H. replied 4 years ago.

Do all the controls work on the dash?

 

The blower speed control often fails so that would be the place to check for power. Do you have a testlight or voltmeter?

 

 

Customer: replied 4 years ago.

yes

 

Expert:  George H. replied 4 years ago.

Ok, behind the glove box check the dark blue wire for power on the power module connector. The procedure below shows a blower resistor but it is in the same location

 

Click here for procedure

 

Let me know what you find

 

Thanks

 

 

Customer: replied 4 years ago.

The plug behind the heater /AC has no juice ..and the power locks won't work either ...is there another fuse box ?

Expert:  George H. replied 4 years ago.

Try removing the negative battery cable for 30 seconds then reconnecting. This will clear any stored codes and allow the computers to reset.

 

The AC controls (a computer) sends a request to the IPM (fuse block, another computer) to turn on the blower relay when you switch it on. If the fuse block sees something that would prevent safe operation of the blower such as a short it will set a code and not turn the relay on.

 

If you can reset it by clearing the codes you will need a shop with a DRB3 scantool to pull the codes and then it may need to be reprogrammed or repaired.

 

Let me know if clearing it restores operation.

 

Thanks

 

 

 

 

George H. and other Chrysler Specialists are ready to help you

Related Chrysler Questions