How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask marcpod Your Own Question
marcpod
marcpod, Own collision repair advice
Category: Chrysler
Satisfied Customers: 2881
Experience:  i-car/ASE/Basf training, 300 repairs and 650,000 in Collision monthly 18yrs exp/ licensed adjuster
17579256
Type Your Chrysler Question Here...
marcpod is online now
A new question is answered every 9 seconds

How to change battery in 2000 300m

Customer Question

how to change battery in 2000 300m
Submitted: 6 years ago.
Category: Chrysler
Expert:  marcpod replied 6 years ago.

graphicWelcome Here is the procedure let me know if you need anything.

WARNING: TO PROTECT THE HANDS FROM BATTERY ACID, A SUITABLE PAIR OF HEAVY DUTY RUBBER GLOVES, NOT THE HOUSEHOLD TYPE, SHOULD BE WORN WHEN REMOVING OR SERVICING A BATTERY. SAFETY GLASSES ALSO SHOULD BE WORN.

REMOVAL

  1. Turn the steering wheel all the way to the right.
  2. Verify that the ignition switch and all accessories are OFF.

 

  1. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
  2. Remove air cleaner housing.
  3. Remove battery splash shield.
  4. Remove two short bolts to battery hold down.
  5. Slide battery rearward to disconnect the negative and positive battery terminals from battery.
  6. Slide battery toward rear of vehicle and lift out of the engine compartment.
  7. Remove battery from vehicle.

INSTALLATION
For installation, reverse the above procedures. Inspect and clean battery and attaching components before installation.

WARNING: DO NOT OVER TIGHTEN BATTERY CABLE CLAMPS, DAMAGE TO CLAMPS CAN RESULT .

  1. Tighten clamp nuts to 8.5 Nm (75 in. lbs.) torque.

LH vehicles do not use a heated air inlet system. The Powertrain Control Module (PCM) adjusts fuel injector pulse width and ignition timing to compensate for different ambient temperatures.

The air cleaner attaches to the a bracket on right inner fender panel. An opening in the body panel connects the inlet duct to ambient air.

The air induction system uses 2 resonator between the air cleaner and throttle body.

Related Chrysler Questions