How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Chrysler Question Here...
brownjeff is online now
A new question is answered every 9 seconds

How do I change the battery in a 2004 Chrysler Sebring convertible?

Resolved Question:

How do I change the battery in a 2004 Chrysler Sebring convertible?
Submitted: 6 years ago.
Category: Chrysler
Expert:  brownjeff replied 6 years ago.
Hello and Welcome to JustAnswer,

My name is XXXXX XXXXX I am here to try and assist your with your question. I will attach information on the battery.

REMOVAL
The battery is accessible without removing the left front wheel and tire assembly..

  1. Verify that the ignition switch and all accessories are OFF.
  2. Turn the steering wheel to the full left position.
  3. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.

WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.

  1. Remove battery splash shield.
  2. Disconnect the heater blanket cord, if equipped.
graphic


  1. Remove the short bolt from the battery hold down and remove the hold down.
  2. Disconnect the negative and positive battery cables from the battery.
  3. Slide the battery toward rear of vehicle and lift out of the battery tray.
  4. Remove battery from vehicle.

INSTALLATION

  1. Position the battery in the battery tray.
  2. Connect the positive and negative battery cables. Torque to 16 Nm (150 in. lbs.) .
  3. Connect the heater blanket cord, if equipped.
  4. Install the battery hold down and install the hold down bolt. Torque to 16 Nm (150 in. lbs.) .
  5. Install battery splash shield.
  6. Connect the negative battery cable.
brownjeff and other Chrysler Specialists are ready to help you

Related Chrysler Questions