How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Z. Your Own Question
Ron Z.
Ron Z., - Chrysler Tech -
Category: Chrysler
Satisfied Customers: 18692
Experience:  18+yrs experience. State Inspector & Chrysler Diagnostics
18617752
Type Your Chrysler Question Here...
Ron Z. is online now
A new question is answered every 9 seconds

WHAT CAUSES THE GEAR SHIFT NOT TO GET OUT OF PARK

Resolved Question:

WHAT CAUSES THE GEAR SHIFT NOT TO GET OUT OF PARK?
Submitted: 6 years ago.
Category: Chrysler
Expert:  Ron Z. replied 6 years ago.

This is actually a very common problem with ALL Chysler vehicles. There is going to be a broken piece inside the shifter that will need to be replaced. The shifter assembly is most likely going to need to b e changed. This should be done by a Dealer who is familiar with this problem. Probably not the best job for a DIY'er to attempt. At this point, the best bet is to use the "over-ride" feature and get it repaired as soon as you can.

 

In the event of an electrical failure, the vehicle can be shifted out of PARK by using the following procedure.

Attachments are only available to registered users.

Register Here

1. Turn the key to the ACC or ON position.
2. Remove the liner to the cubby bin to the right side of the shifter.
3. Depress the BTSI override (2) on the side of the shifter assembly (1).
4. While the override is depressed, move the shifter out of the PARK position.
5. Return the cubby bin liner to its original location.

Ron Z. and 7 other Chrysler Specialists are ready to help you

Related Chrysler Questions