How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Chrysler Question Here...
brownjeff is online now
A new question is answered every 9 seconds

2002 Town & Country: intermittent../ both Driver side..pass side

Customer Question

2002 Town & Country, Passenger Side Window intermittent up/down function. w/ both Driver side and pass side window switch operation. Window doesn't go up all the way may only work for a couple seconds then cut out. Same with down operation.''

Is it likely motor or switch? How is Door trim secured? 2 screws and push pins? ro is it molded in lift to remove?
Submitted: 6 years ago.
Category: Chrysler
Expert:  brownjeff replied 6 years ago.
Most likely the problem is the motor.

Here is how to remove the door panel:

REMOVAL

  1. Remove the plug and remove screw attaching door pull cup to inner door panel.
  2. Remove switch bezel and disconnect power window/memory switch.
  3. Remove screws attaching trim panel to door from below map pocket.
  4. If equipped, remove window crank.
  5. Remove screw holding door trim to door panel from behind inside latch release handle.
  6. Disengage clips attaching door trim to door frame around perimeter of panel.
  7. Lift trim panel upward to disengage flange from inner belt molding at top of door.
  8. Tilt top of trim panel away from door to gain access to latch linkage.

Attachments are only available to registered users.

Register Here

Attachments are only available to registered users.

Register Here

  1. Disengage clip attaching linkage rod to inside latch release handle (Fig. 22).
  2. Separate linkage rod from latch handle.
  3. Disconnect the power door switch, courtesy lamp electrical connectors.
  4. Remove front door trim panel from vehicle.
Click here to download file