How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris Your Own Question
Chris
Chris, Technician
Category: Chrysler
Satisfied Customers: 13144
Experience:  30 years certified Chrysler technician, smog license Certified Master Technician
12365498
Type Your Chrysler Question Here...
Chris is online now
A new question is answered every 9 seconds

Where is the thermostat located on a 2004 sebring convertible

Resolved Question:

where is the thermostat located on a 2004 sebring convertible
Submitted: 6 years ago.
Category: Chrysler
Expert:  Chris replied 6 years ago.

Hello and welcome to just answer Chrysler. It is at the lower left front side of the engine. Here is a description of it's location for you.

Hope this helps, and let me know if you need more assistance with this.

 

Chris

 

REMOVAL - 2.7L

  1. Disconnect negative cable from remote jumper terminal.

    WARNING: DO NOT REMOVE PRESSURE CAP OR ANY HOSE WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.

  2. Drain cooling system (Refer to 7 - COOLING/ENGINE - STANDARD PROCEDURE).
  3. Raise vehicle on hoist.
  4. Remove right front wheel and belt splash shield.
  5. Remove accessory drive belts (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL).
  6. Remove lower generator mounting bolt.
  7. Lower vehicle.
  8. Disconnect generator electrical connectors.
  9. Disconnect AC clutch and AC pressure sensor electrical connectors. Reposition wiring harness.
  10. Remove oil dipstick and tube. Plug hole in oil pan where dipstick tube mounts with water tight stopper.

    WARNING: IF HOLE FOR DIPSTICK TUBE IN OIL PAN IS NOT PLUGGED, COOLANT WILL ENTER OIL PAN. SERIOUS ENGINE DAMAGE CAN OCCUR.

  11. Remove remaining generator mounting bolts. Remove generator.
  12. Disconnect hoses at thermostat housing.
  13. Remove thermostat housing bolts (Thermostat and Housing - 2.7L Engine).
  14. Remove thermostat and housing.

1 - THERMOSTAT AND GASKET
2 - THERMOSTAT HOUSING/COOLANT INLET

Chris and other Chrysler Specialists are ready to help you

Related Chrysler Questions