How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Aftermarket & Factory Electronics
Category: Chrysler
Satisfied Customers: 20602
Experience:  Cert. Chrysler Warnty, Heavy Line Mech, Mobile Electronics. Sales, Installation & Repair for 30 years
1609972
Type Your Chrysler Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

2007 chrysler sebring: a remote starter..diagrams..door locks

Customer Question

hi iam installing a remote starter in my 2007 chrysler sebring 4 door with a 4 cyl engine i need wirering diagrams for the starter switch and the door locks thank you dm.
Submitted: 7 years ago.
Category: Chrysler
Expert:  john -aka eauto replied 7 years ago.
200" height="25" align="center" valign="middle"> PART COLOR LOCATION
12 VOLT CONSTANT PINK/BLACK (+) and RED (+) IGNITION SWITCH HARNESS
STARTER YELLOW (+) IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 BLUE (+) IGNITION SWITCH HARNESS
IGNITION 2 GREEN/RED (+) 20 Gauge wire IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 BLACK/ORANGE (+) IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 BLACK/WHITE (+) IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BLACK/YELLOW (+) IN DRIVERS KICK PANEL or HEADLIGHT SWITCH
POWER LOCK WHITE/GREEN (1-Wire Door Lock System) See NOTE *1 @ BCM, Connector 4, Pin 15, See DAIGRAM
POWER UNLOCK Same wire, See DIAGRAM See DIAGRAMS
DOOR TRIGGER See NOTE *4 @ BCM, Connector 4, Pins 5 and 6, See NOTE *3
DOMELIGHT SUPERVISION YELLOW (-), Requires #R30-H Relay @ FRONT of FUSEBOX, 6-Pin Plug
TRUNK RELEASE GREEN/WHITE (5-Wire) See NOTE *5 @ BCM, Connector 4, Pin 1, See NOTE *3
SLIDING POWER DOOR N/A
HORN BLACK/RED (-) @ STEERING COLUMN HARNESS
TACH ANY wire that is NOT GREEN/LIGHT GREEN @ Any COIL or FUEL INJECTOR
WAIT TO START LIGHT N/A
BRAKE WHITE/TAN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM LIGHT GREEN/ORANGE (+) See NOTE *2 @ BCM, Connector 4, Pin 4, See NOTE *3
ANTI-THEFT CHRYSLERS SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM TRANSPONDER @ IGNITION SWITCH TUMBLER
EXTRA INFORMATION
NOTE *1 This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive thru a 2700 Ohm Resistor to LOCK and a (+)Positive thru a 620 Ohm Resistor to UNLOCK, some units will also require 2 extra relays part #R30-H to connect, See DIAGRAM NOTE *2 To DISARM requires a (+)Positive thru a 750 Ohm Resistor and an extra Relay part #R30-H to connect, See DIAGRAM NOTE *3 The BCM (Body Control Module) is located under the DRIVERS SIDE of DASH and is attached to the FUSE/RELAY box. Connector 4 is a 26 pin plug at the bottom edge of the BCM. NOTE *4 this vehicle uses 4 door pin triggers, at the BCM Connector 4, the DRIVERS DOOR is a TAN (-) Pin 5, the PASSENGERS DOOR is a TAN/RED (-) Pin 6, the DRIVERS REAR DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW, Pin 8. When connecting to an ALARM SYSTEM, use all 4 wires and DIODE ISOLATE. See DIAGRAM NOTE *5 the TRUNK/HATCH Release on this vehicle is a 5-Wire System and will require an extra Relay Part #R30-H, to connect, See DIAGRAM.
Expert:  john -aka eauto replied 7 years ago.
any further questions feel free to ask...if my answer was useful please hit accept
Customer: replied 7 years ago.
i have this diagram it is good for 2006 sebring but the car changed in 2007 my ignition wire colors are nothing like this.
Expert:  Don 'Mo Lurch' replied 7 years ago.

 

Customer...............

Another Expert here.................

This vehicle needs a number of Resistors to correctly install a Remote Start, Keyless Entry, etc.

To make the Installation much simpler & have very few problems, you need to use a DATA Module like the IDATA Unit (click) >> HERE

The DATA Module will give you the Second Starter & Accessory without the use of Resistors & also maintain the integrity of the Factory Transponder / Alarm System.

 

If you need further, let me know

 

Here is Wiring sheet also

 

 

Attachments are only available to registered users.

Register Here

Attachments are only available to registered users.

Register Here

Attachments are only available to registered users.

Register Here
View Full Image

Attachments are only available to registered users.

Register Here

Don 'Mo Lurch', Aftermarket & Factory Electronics
Category: Chrysler
Satisfied Customers: 20602
Experience: Cert. Chrysler Warnty, Heavy Line Mech, Mobile Electronics. Sales, Installation & Repair for 30 years
Don 'Mo Lurch' and 7 other Chrysler Specialists are ready to help you