How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask John Your Own Question
John, triple chrysler master tech
Category: Chrysler
Satisfied Customers: 2251
Experience:  43 years,triple chrys ,ase master tech,l1,t2 b5 a1-a8 Hev spec.
Type Your Chrysler Question Here...
John is online now
A new question is answered every 9 seconds

how do I change the starter on a 1996 V6 chrysler sebring

Customer Question

how do I change the starter on a 1996 V6 chrysler sebring?
Submitted: 6 years ago.
Category: Chrysler
Expert:  John replied 6 years ago.
Hi my name is john.

which engine do you have?

Is this a coupe,conv,or sedan?
Customer: replied 6 years ago.
I'm pretty sure it is a 2.5L, I know it's a 6 cly, it is my mother's car. It is a convertible. I believe the starter is located at the front bolted to the engine with an exhaust pipe very close.
Expert:  John replied 6 years ago.
  1. Disconnect battery ground cable from remote ground terminal on shock tower.
  2. Raise and support vehicle.
  3. Remove oil filter.
  4. Remove battery positive cable nut from starter and remove cable.
  5. Disconnect push-on solenoid connector.
  6. Remove three bolts attaching starter to transaxle housing and remove starter from vehicle.
  7. Reverse procedure to install. Clean corrosion from wire terminals before installation
Let me know what else you need.

If I have help you, please push the accept button when were done.

Thank you for choosing just answer
John and other Chrysler Specialists are ready to help you
Customer: replied 6 years ago.

Thank You. So the starter has a positive cable from batt and another cable. Dissconnect both. Remove oil lilter, Unbolt starter. I think I have it. Do I need any special tools?

Expert:  John replied 6 years ago.
not really, some have shim between the starter and the engine.

There is the positive battery cable and a little wire bolted to the starter solenoid.
Customer: replied 6 years ago.

Thank you very much. I think I need to get an oil filter wrench and an extension for my socket but I'll give it a try tomorrow afternoon. Thanks again.



Expert:  John replied 6 years ago.
Your welcome,if you need more just come back to this question.

Thank you