How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Chrysler Question Here...
brownjeff is online now
A new question is answered every 9 seconds

2002 Chrysler Sebring: Sorry where is the starter located..LXI..DIY

Customer Question

Sorry where is the starter located on a 2002 Chrysler Sebring LXI Convert located? Signed DIY
Submitted: 7 years ago.
Category: Chrysler
Expert:  brownjeff replied 7 years ago.

Here are some pictures with the procedure to remove it.

 

REMOVAL

  1. Open Hood.
  2. Disconnect the negative battery cable.
  3. Raise vehicle and support.
  4. Disconnect the electrical connector from the O2 sensor.

Fig.6 O2 Sensor

  1. Remove the O2 sensor from the exhaust manifold (Fig. 6).
  2. Remove the front mount through bolt.
  3. Remove the front mount bracket from engine block.

Fig.7 Starter Motor

  1. Remove the battery cable from starter (Fig. 7).

Fig.8 Starter Motor Removal

  1. Remove the lower starter bolt and remove starter (Fig. 8).

INSTALLATION

  1. Install starter to transmission.
  2. Start the upper starter bolt.
  3. Start the lower bolt and snug it so that the starter will not move.
  4. Remove the upper bolt.
  5. Connect the battery cable and torque nut to 8.5 Nm (75 in. lbs.) .
  6. Install the front mount bracket and check heat shield location.
  7. Install bolt the upper bolt and torque bolt to 54 Nm (40 ft. lbs.)
  8. Install the lower and torque bolt to 54 Nm (40 ft. lbs.)
  9. Install the front mount through bolt and torque bolt to 61 Nm (45 ft. lbs.)
  10. Install the O2 sensor and torque to 27 Nm (20 ft. lbs.)
  11. Lower vehicle.
  12. Connect the negative battery cable.
brownjeff, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 13886
Experience: 17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
brownjeff and 8 other Chrysler Specialists are ready to help you
Expert:  moparfl replied 7 years ago.
I see That I was requested to answer this but the info you got is correct.