How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
Type Your Chrysler Question Here...
brownjeff is online now
A new question is answered every 9 seconds

Remove crankshaft pulley on 2006 chrysler 300 with 2.7 engine

Customer Question

how do you remove crankshaft pulley on 2006 chrysler 300 with 2.7 engine
Submitted: 7 years ago.
Category: Chrysler
Expert:  brownjeff replied 7 years ago.

Here are the instructions on removing the pulley.


If you still need help just reply, if not click ACCEPT when we are done.









  1. Disconnect negative battery (1) cable located in trunk.
  2. Remove accessory drive belts.

  1. Use special tool 9365 Damper Holder (2) to hold damper (1) while removing attaching bolt (3).

  1. Remove damper by using Special Tools 8194 Insert (1) and 8454 Puller (2).


  1. Install damper (1) using Special Tools 8179 Screw (3), with Nut and Thrust Bearing from 6792, and 6792-1 Installer (2).

  1. Install damper attaching bolt (3). Use special tool 9365 damper holder (2) to hold damper (1) while tightening attaching bolt to 170 Nm (125 ft. lbs.) .
  2. Install accessory drive belts.

  1. Connect negative battery (1) cable located in trunk.


Customer: replied 7 years ago.
is this a harmonic balancer removal kit if so can i buy or rent it
Expert:  brownjeff replied 7 years ago.
Yes that is what you need. Most parts stores sell these and some rent them as well.
brownjeff and other Chrysler Specialists are ready to help you
Customer: replied 7 years ago.
all the diagrams that u sent to go along with instructions are blank
Expert:  brownjeff replied 7 years ago.




Not sure what happened......I will try again. Two were just a picture of the battery, but here are the ones you need.









Related Chrysler Questions