How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask stevets 61 Your Own Question
stevets 61
stevets 61, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 134
Experience:  10 years chrysler/jeep dealership experience-ASE master certified-Chrysler certified
12105596
Type Your Chrysler Question Here...
stevets 61 is online now
A new question is answered every 9 seconds

how do I change the fuel filter on my 1995 Chrysler New yorker.

This answer was rated:

how do I change the fuel filter on my 1995 Chrysler New yorker.

HiCustomer

The fuel filter is in the rear on the passenger side just before the wheel.There are two ways they connect the hoses.

One is with clamps, which you just use a screwdriver and loosen the clamps.

The other is with clips.Clean the area around the clamps and spray some wd-40 in the clip.Then push the clip into the hose and pull the hose off the filter.

Here are some pics. steve

 

Fuel Filter Location


REMOVAL

  1. Disconnect the negative battery terminal, and remove the fuel tank cap.
  2. Raise, and support the vehicle for access.
  3. Remove fuel filter hoses and clamps from the inlet and outlet fuel nipples. Remove the retaining strap bolt, and remove the filter.

INSTALLATION

  1. Install the new filter in the retaining strap. Check the direction of flow by the markings on the filter, and ensure it is correct.
  2. Install the retaining strap bolt, and torque to 8.8 ft-lbs (12 Nm)
  3. Install the inlet and outlet hoses, and clamps. Tighten the clamps securely. Lower the vehicle. Connect the negative battery terminal
stevets 61 and other Chrysler Specialists are ready to help you

Related Chrysler Questions