How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask garrtim Your Own Question
garrtim
garrtim, service manager
Category: Chrysler
Satisfied Customers: 6277
Experience:  20+ years chrysler certified
6531745
Type Your Chrysler Question Here...
garrtim is online now
A new question is answered every 9 seconds

How to install a blower motor on a 2004 town & country

Customer Question

How to install a blower motor on a 2004 town & country
Submitted: 8 years ago.
Category: Chrysler
Expert:  garrtim replied 8 years ago.

hello, do you have the old motor out yet?tim

and are we talking about the front blower?

Customer: replied 8 years ago.
no, It is the front blower. Just woundering is there anything tricky about this replacement.

Expert:  garrtim replied 8 years ago.

yes there is ,tim

NOTE: The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel
  3. Position the carpet to access the front upper screw that secures the air inlet housing
  4. Remove the recirculation door actuator
  5. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
  6. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
  7. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing.
  8. Push the rubber grommet through the opening in the lower air inlet housing
  9. Route the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
  10. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing
  11. Gently flex the recirculation-air door downward to gain access to remove the blower motor from the HVAC housing.

    NOTE: To aid in installation, note the position of the blower motor mounting tabs prior to removal.

  12. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as necessary .

 

garrtim and 4 other Chrysler Specialists are ready to help you
Customer: replied 8 years ago.
`What do you think...... Can a back yard mechanic do this? Is there anything in particular difficult with this procedure?
Expert:  garrtim replied 8 years ago.

think positive -- you can do it -- here is a pic -- thanks for the accept,tim

1 - LOWER INTAKE AIR HOUSING
2 - RECIRCULATION DOOR ACTUATOR
3 - HVAC WIRE HARNESS
4 - SCREW (2)
5 - LOWER EVAPORATOR HOUSING

Related Chrysler Questions