How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Chrysler Question Here...
brownjeff is online now
A new question is answered every 9 seconds

how to change the thermostst in a 2000 300m

Customer Question

how to change the thermostst in a 2000 300m
Submitted: 8 years ago.
Category: Chrysler
Expert:  brownjeff replied 8 years ago.

I will attach instructions.

 

If you still need help just reply, if not click ACCEPT when we are done.

 

Thanks,

 

JB

 

REMOVAL

WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.

  1. Disconnect negative cable from remote jumper terminal.
  2. Drain cooling system. Refer to Cooling System, Service and Repair, Service Procedures.
  3. Raise vehicle on hoist.
  4. Disconnect electrical connectors from engine of: and power steering pressure switches.
  5. Disconnect radiator and heater hoses from thermostat housing.

  1. Remove thermostat housing bolts.
  2. Remove housing, thermostat, and gasket.

INSTALLATION

  1. Clean gasket sealing surfaces.
  2. Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention.
  3. Install thermostat and housing to cylinder block. Tighten bolts to 12 Nm (105 inch lbs.) .
  4. Connect heater and radiator hoses. Install hose clamps.
  5. Connect electrical connectors to engine oil and power steering pressure switches.
  6. Lower vehicle and connect negative cable to remote jumper terminal.
  7. Refill cooling system.

 

 

Customer: replied 8 years ago.
any chance you can attach the full image of the housing? the link will not let me pull it up in alldata... thanks in advance
Expert:  brownjeff replied 8 years ago.

How is this?

 

1 - THERMOSTAT HOUSING/COOLANT INLET
2 - THERMOSTAT
3 - GASKET
brownjeff and 3 other Chrysler Specialists are ready to help you
Customer: replied 8 years ago.
perfect - thank you

Related Chrysler Questions