How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ryan Schott Your Own Question
Ryan Schott
Ryan Schott,
Category: Chevy
Satisfied Customers: 82
Experience:  technician at Demarois Buick Gmc
Type Your Chevy Question Here...
Ryan Schott is online now
A new question is answered every 9 seconds

How do I replace the driveshaft center carrier barring on a

Customer Question

how do I replace the driveshaft center carrier barring on a 98 Chevy S10
Submitted: 3 months ago.
Category: Chevy
Expert:  Ryan Schott replied 3 months ago.

if you have a press its best to press it out with a bearing clamp around it. If not you can set it in a vice and using a brass hammer or drift beat the driveline through it, once the old ones off find a peice of pipe that fits nicely around the driveline and hits the bearing and drive the new one on, note the orientation of the old bearing before you remove it so the new one goes on the same way, if it really wont budge you can cut it off but you will have to cut in two places. You will still need a pipe to install the new one though.

Expert:  Ryan Schott replied 3 months ago.

you get it on?

Related Chevy Questions