How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dan Your Own Question
Dan
Dan, Technician
Category: Chevy
Satisfied Customers: 23591
Experience:  Independent Shop Experience, 2 Year Automotive Diploma, & Access to Information Database
17871496
Type Your Chevy Question Here...
Dan is online now
A new question is answered every 9 seconds

2000 s10 2.2 motor no fire to the plug wires I changed the

Customer Question

2000 s10 2.2 motor no fire to the plug wires I changed the ignition control module still no fire
JA: Have you checked all the fuses? Do you have a wiring diagram?
Customer: yes all the fuses. no wiring diagram
JA: What is the model of your '00 Chevy?
Customer: 2000
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: yes. new ignition control module
JA: Anything else you think the mechanic should know?
Customer: no
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Chevy Mechanic about your situation and then connect you two.
Submitted: 5 months ago.
Category: Chevy
Expert:  Dan replied 5 months ago.

Hello, my name is***** to see if pink wire going to ignition module has power with key in on position and start position. Thanks.

Customer: replied 5 months ago.
im not where the truck is ;at this time.
Expert:  Dan replied 5 months ago.

No problem, just let me know when you get a chance to check. Thanks.

Customer: replied 5 months ago.
don't call that(###) ###-##### *****
Expert:  Dan replied 5 months ago.

No problem, just let me know when you get a chance to check wire for power and we will go from there. Thanks.

Customer: replied 5 months ago.
im going to the truck give about 30
Expert:  Dan replied 5 months ago.

Sounds good, let me know how it goes. Thanks.

Customer: replied 5 months ago.
PINK WIRE IS HOT
Expert:  Dan replied 5 months ago.

Make sure black/white wire has good ground. If so next step is to check wiring between crank sensor and ignition module, if good replace the crankshaft position sensor. Here is a wiring diagram to help with testing, let me know if you have more questions. Thanks.

-

https://www.dropbox.com/s/lx1kpxfhj3hw9ur/ckps.pdf?dl=0

Customer: replied 5 months ago.
THIS 2.2 MOTOR DONT HAVE CRANK SENSOR
Expert:  Dan replied 5 months ago.

Yes it does, here is a picture of it. Every vehicle has a crank sensor.

-

https://www.dropbox.com/s/o4qzc9t8sktma7u/ckpsrr.pdf?dl=0

Customer: replied 5 months ago.
dan I found the crank sensor thanks
Expert:  Dan replied 5 months ago.

Good to hear, make sure to test wiring before replacing crank sensor. Let me know if you run into more questions, you can reply at any time without additional fees even after leaving rating. Thanks!