How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Master Tech
Category: Chevy
Satisfied Customers: 12744
Experience:  ASE Master, L1, 32 years, Diagnostic / Electrical Specialist
13677702
Type Your Chevy Question Here...
Randall C is online now
A new question is answered every 9 seconds

On a 305 chevy motor crank arrows face forward or to the back

Customer Question

on a 305 chevy motor crank arrows face forward or to the back main
Submitted: 8 months ago.
Category: Chevy
Expert:  Randall C replied 8 months ago.
hello, can you reword the question? what do you mean by " crank arrows" what work are you doing?
Customer: replied 8 months ago.
main caps on 305 chevy dont know how to put them back arrows on caps face to the back of the block
Expert:  Randall C replied 8 months ago.
ALL main bearing caps have the arrows facing the FRONT of the engine, Not the back, here is direct from the manual to show 100% this is correct wayInstall the crankshaft bearing caps in the original positions and with the arrow on the crankshaft bearing caps in the direction of the front of the engine block.NOTICE: Refer to Fastener Notice in Service Precautions. Install the crankshaft bearing cap bolts and the crankshaft bearing cap studs.6.1.Tighten the crankshaft bearing cap bolts and the crankshaft bearing cap studs on the first pass to 20 Nm (15 lb ft) .6.2.Tighten the crankshaft bearing cap bolts and the crankshaft bearing cap studs (two bolt caps) on the final pass to 73°using the J 36660.6.3.Tighten the crankshaft bearing cap outboard bolts and the crankshaft bearing cap outboard studs (four bolt caps) on the final pass to 43°using the J 36660.6.4.Tighten the crankshaft bearing cap inboard bolts and the crankshaft bearing cap inboard studs (four bolt caps) on the final pass to 73°