How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ryan Schott Your Own Question
Ryan Schott
Ryan Schott,
Category: Chevy
Satisfied Customers: 83
Experience:  technician at Demarois Buick Gmc
77508644
Type Your Chevy Question Here...
Ryan Schott is online now
A new question is answered every 9 seconds

My security light blinks took wont start, My truck security

Customer Question

My security light blinks took wont start
JA: Tell me a bit more about what's going on so he can help you best.
Customer: My truck security light blinks truck would not start
JA: Are you hoping to fix this yourself?
Customer: Yes
JA: Great! What have you tried so far?
Customer: I tried looking for a fuse that make controlled it
JA: Is there anything else important you think the Chevy Mechanic should know about your Chevy?
Customer: I have replaced the switch The sweets house now and wires
JA: I'm sending you to a secure page on JustAnswer so you can place the $5 fully refundable deposit now. While you're filling out that form, I'll tell the Chevy Mechanic about your situation and connect you two.
Submitted: 8 months ago.
Category: Chevy
Expert:  Ryan Schott replied 8 months ago.

Sorry to hear about the trouble. can you shoot me your VIN so i can pull up the correct vehicle build. I think auto correct gummed up the info i was sent you replaced the ignition switch and what else?

Customer: replied 8 months ago.
The House -for the switch and wire
Expert:  Ryan Schott replied 8 months ago.

gotcha, can you send me the VIN or year make and model for starters.

Customer: replied 8 months ago.
1gccs145328241512
Expert:  Ryan Schott replied 8 months ago.

is it a blazer pickup or trailblazer? VIN brought up all 3

Customer: replied 8 months ago.
2002 Chevrolet s10
Customer: replied 8 months ago.
Four cylinder
Customer: replied 8 months ago.
Automatic
Expert:  Ryan Schott replied 8 months ago.

Got it, did you try performing the 30- min theft learn procedure

30 Minute Learn Procedure

Important: The vehicle learns the Passlock™ Sensor Data Code and/or password ***** the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON, vehicle will not start.
  3. Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF.
  4. Turn OFF the ignition, and wait 5 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes, the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
  6. Start the engine, the vehicle has now learned the Passlock™ Sensor Data Code and/or password.
  7. With a scan tool, clear any DTCs if needed, history DTCs will self clear after 100 ignition cycles.
Expert:  Ryan Schott replied 8 months ago.

That get it started for you?